SUHNER ABRASIVE LLG 4 Documentación Técnica página 16

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LLG
4.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for purposes for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives. The
machine is intended exclusively for 2-hand working op-
erattions.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. c
2.1 p
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 f
itting of hose coupling
Fitting of hose coupling inside diameter min. 7mm (avail-
able as optional accessory, item no. 90805700).
16
s
otes on aFety
ommIssIonIng
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Max. chuck diameter
Sound pressure level EN ISO 15744 77dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o
perAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 f BsgV 35
itting of
Release fixation with hook wrench no. 30/32. Screw in
adapter and tighten down (for torque and data on Loctite
max. 6.3bar
900W
1.1m /min
3
0.6m /min
3
about 2-3 drops/min
4000min
-1
200mm
10mm / 3/8"
4.9m/s , K=2.4m/s
2 2
3/4/4
1.700kg
/ o
PeratIon
AdApter