Connection To Mains - J.P. SELECTA SEAL-1000 Manual De Instrucciones

MANUAL DE INSTRUCCIONES CODIGO 80207 REV A
Place the buffer rules according to
roll size.
Sealing temperature selection knob.
Geen lamp
Wait for green lamp becomes Off to
perform the seal.
J
.P. SELECTA s.a.u.
May/2016
7 Starting-up the sealing machine
Place the unit over a fl at surface, levelled, stable and suitable for the unit weight. A
mains socket near than 1.5m will be necessary.
To work comfortable, let a free space of about 50cm around the sealing machine.

7.1 Connection to mains

Locate a power supply socket (rated to 16A) near to the unit. Use the power cord
supplied or another of similar specifi cations.
For safety reasons, the socket must have ground terminal, since the unit must work
grounded.
Before plugging the mains, check than voltage matches the one indicated on the
unit plate.
7.2 Sealing machine set up
1. Loading paper roll
Place the paper roll on the stand and the buffer rules to avoid the side moving.
Insert the paper in the sealing head form the rear side.
Inserting the paper to the sealing head.
2. Set the sealing temperature
Use the sealing temperature selection knob to adjust the optimal temperature accord-
ing paper type. We suggest to run some tests before setting the properly temperature
As a general rule, set the knob between point number 3 and 4.
It is not recommended to use a temperature knob set over point 4.
3. Wait the indication «Ready to seal»
Once the mains switch is On, the unit starts to heat the sealing area. During this
time the green lamp is On.
When the green lamp becomes Off, the unit will be ready to seal.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(Sujetas a modifi caciones sin previo aviso)
Pull the paper from the head front side.
Tel 34 937 700 877 Fax 34 937 702 362
Pág..: 10