Festool PLANEX LHS 225 Guía De La Aplicación página 7

Application optimisation guidelines
Troubleshooting Procedure
Extractor blows Clean the filter element retainer in the
out dust extractor and check the filter is installed
correctly (19), replace the filter if
leaking (20)
Acoustic warning Select the correct suction hose diameter
signal on the (for PLANEX use D = 36 mm)
extractor sounds
Use the adapter (21) with bypass function
when working with the RTS/RS 400,
DTS/DS 400, ETS/ES 125, article
number 496112
12
19 20
21
PLANEX sanding recommendations
Filler hardness Internal/ Suction setting
External extraction
Extremely soft External extraction 6 for external
only extraction
Soft External extraction 6 for external
only extraction
Average Internal and 1 – 3 for
external extraction internal extraction
6 for external
extraction
Extremely hard Flat surfaces 1 – 3 for
> internal extraction internal extraction
Uneven surfaces 6 for external
> external extraction extraction
Note: the perfect PLANEX LHS 225 setup not only depends on the material being machined, but also on the local ambient
conditions such as the surface type, air humidity, working approach of the user, etc.
These sanding recommendations are only guidelines. Always test the setup of the PLANEX LHS 225 at the working location.
These optimisation guidelines do not replace the operating manual supplied with the machine!
Speed setting Abrasive grit
2 – 4 from P 180
2 – 4 from P 180
4 – 6 from P 120
4 – 6 from P 100
www.festool.com 13