SUHNER ABRASIVE LRC 20 Documentación Técnica página 18

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LRC
20.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine is designed to drive the SUHNER extension
systems (VSC). The machine is designed for grinding,
milling, and deburring metal, stone, and plastic with burrs
and abrasives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner AG, Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the prod-
uct with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. CH-Lupfig, 10/2019.
T. Fischer/Managing Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see
also air quality under section 2.3).
Observe national regulations. See
the SUHNER assembly instructions for installing exten-
sion systems.
18
s
otes on aFety
ommIssIonIng
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 69.5dB(A), K=3dB(A)
Air quality DIN ISO 8573-1
Weight with hose
2.3.1 e din 10 / g28
xtension systems
VSC 500 (500mm)
VSC 1000 (1000mm)
VSC 1500 (1500mm)
2.4 o
PerAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 t
ools
See the SUHNER VSC installation instructions, for
changing and installing tools and for work instruc-
tions.
max. 6.3bar
350W
0.67m /min
3
0.28m /min
3
about 1-2 drops/min
20000min
-1
3/4/4
0.380kg
Vibration EN ISO 28927-12
6.2m/s , K=3.0m/s
2 2
7.0m/s , K=3.0m/s
2 2
8.0m/s , K=3.0m/s
2 2
/ o
PeratIon