Machine Preparation (When Required); Coupling To The Tractor - Checchi & Magli F 300 L Manual De Uso Y Manutención

9.0 - MACHINE PREPARATION (WHEN REQUIRED)

The machine may have been shipped partially disassembled in order to reduce the
overall size. Assemble making reference to Fig. 5 and to the drawings in the spare
parts catalogue, from page 63 to page 65.

10.0 - COUPLING TO THE TRACTOR

10.1 - The machine must be coupled to the tractor on flat ground.
10.2 - Check that the three-point linkages are of a compatible category.
10.3 - Bring the tractor up to the machine, taking care not to get between the two
at this stage, and proceed with coupling only when the tractor is stationary. Fix the
three coupling arms with the relative pins and insert the appropriate safety split pins
(fig. 6).
10.4 - Limit sideways movements and keep the machine parallel with the tractor,
using the stabilizer chains and arm adjustment device (fig. 7).
10.5 - Adjust the third point arm until the machine coupling is at right angles (fig. 8).
10.6 - If applicable, position the support foot as shown in fig. 9.
32
F 300 L
FIG. 5