Ford F-Serie Manual De Instrucciones página 55

Ocultar thumbs Ver también para F-Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Scuff sand only, DO NOT GRIND, the inner structure bonding surfaces. Do not sand to bare substrate, leave
original e-coat as intact as possible.
11. Trial fit the service replacement panel to the door shell assembly.
12. Temporarily secure the outer panel to the door assembly and install on the vehicle to verify proper
skin alignment.
13. Use reference marks to assist.
14. Scuff the replacement skin bonding areas, then clean with adhesive cleaner.
15. Apply metal bonding adhesive to the following areas: service replacement hem flange, flutter beam-to-outer
panel, and outer belt reinforcement-to-outer panel. (Refer to figure 1).
16. Using a 501-080 Hem Closing Tool or the hammer and dolly method, close the perimeter door hem and smooth
any residual adhesive in the joints.
17. Install eight (8) (W708717) SPR rivets code AW or eight (8) W790376-S900 solid rivets. (Refer to Figure 2).
18 Prime and Paint the door following Ford approved paint company materials/guidelines.
19. Install the door to the vehicle, align, and reassemble all components.
20. Apply anti-corrosion treatments as outlined in workshop manual section 501-35.
21. (Refer to Figure 1) for location for adhesive material.
NOTE: The location of SPR and adhesive shown below are based on the original production drawings and
should only be used as a guideline. (Refer to Figure 1).
CPR © 2016 FORD MOTOR COMPANY
DEARBORN, MICHIGAN 48121
9-16
SKFL34-1624704-AC
F-SERIES CREW CAB REAR DOOR OUTER PANEL
INSTALLATION - SERVICE KIT INSTRUCTIONS
SHEET 2 OF 3

Publicidad

Tabla de contenido
loading

Tabla de contenido