Brita WHS-201 Instrucciones De Instalación página 11

household filtration
Filter Replacement
(every 3 months)
faucets
sing
ng filter
n and
here the
n the
Note: Place paper towels or rag under the filter housing to catch any water drips.
Before You Begin
ttings
Step 1
g on
Step 2
ompletely.
nd inspect
gured
Step 3
and
Step 4
d call
Step 5
*Note: To prevent leaks and/or housing ruptures, please properly seat filter cartridge at top and bottom within filter housing.
WHS-201 installation instructions
For FREE Filter Replacement Reminder, go to www.protectplus.com
• Turn off household water supply to the home .
• Turn on all faucets in home to drain water lines.
• Press the red pressure relief button.
Unscrew
• Use the wrench to remove the filter housing.
• Careful: Filter housing will contain water .
Filter Housing
• Rinse filter housing.
Clean • Fill 1/3 with water and add 2 tbsp. of Clorox® bleach.
• Wipe Head and Housing .
Filter Housing
• Rinse Filter Head thoroughly to remove bleach.
• Remove and wipe clean o-ring .
Clean and
• Lubricate o-ring with silicone grease .
• Return o-ring and seat securely for a good seal .
Lubricate O-Ring
• Insert new Filter over standpipe in bottom of
Insert New Filter
• Attach Housing to Head and hand tighten .
• Using the Wrench, tighten 1/4 turn .
• Slowly turn on household water supply .
• Press red pressure relief button to release trapped air .
Flush New Filter
• Check for leaks.
• Open the faucet and flush for 40 minutes.
Housing.
DO NOT OVERTIGHTEN.
11 11
Version 2.0F