Festo CPX−Terminal Instrucciones De Instalación página 20

3.2 Assembly
When dismantling the connection block or replacing the
electronic module, the plug and cable can remain on the
connection block.
Dismantling the I/O module:
1. Unscrew screws and carefully lift out the connection
block.
2. If necessary: Carefully remove the electronics module
from the contact rails.
1
Screws, tightening
torque 0.9 to 1.1 Nm
2
Connection block
3
Electrical plug con
nector
4
Electronic module
5
Contact rails
6
Manifold sub−base
Assembling the analogue I/O module:
1. When the electronic module has been removed: press
the electronic module carefully into the interlinking
block.
2. Check seals and sealing surfaces and replace the con
nection block.
20 Festo CPX−AX 0811c English
1
2
3
4
5
6