Iso Ddin Radio Provision - Metra 99-7581 Instrucciones De Instalación

ISO DDIN radio provision

1. Remove the mounting brackets from the
factory radio. Secure the brackets to the
aftermarket radio using screws supplied
with the aftermarket radio.
2. Remove (2) T-20 Torx screws from the a/c
vents, then remove. (Figure A)
3. Secure the ISO DDIN trim plate to the panel
using (2) T-20 Torx screws removed from
the prior step.
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
5. Reassemble the dash in reverse order of
disassembly to complete the installation.
KIT ASSEMBLY
(Figure A)
7
REV. 3/10/2020 INST99-7581