Kit Assembly; Din Radio Provision With Pocket - Metra 99-7581 Instrucciones De Instalación

DIN radio provision with pocket

1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve into the radio housing
and secure by bending the metal locking
tabs down. (Figure A)
3. Slide the radio back into the sleeve until
it clicks in. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
5. Reassemble the dash in reverse order of
disassembly to complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B)
5
REV. 3/10/2020 INST99-7581