How To Operate Your Ceiling Fan; Important - Fanimation STELLAR MAD7998 Serie Manual Del Usuario

How to Assemble Your Light Kit or Cap (continued)
6. Assemble the LED assembly to the light kit using
the previously removed screws and secure all three
screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
light kit
7. Secure the glass to
clockwise direction. Do not over-tighten. (Figure 7)
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
NOTE: The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
by twisting in a

How to Operate Your Ceiling Fan

WARNING
WARNING
Light Kit
LED Assembly
Light Kit
Glass
For illustrative purposes only-not
intended to cover all types of controls
13
Figure 6
Figure 7
Figure 1
MAIN FUSE BOX
Figure 2