Adjusting The Driving Wheel Load; Adjusting The Row Spacing - Checchi & Magli UNIFOX Serie Manual De Uso Y Mantenimiento

12) Tighten the screw (A).
13) Position the other seedling holder in the same way.

Adjusting the driving wheel load

To adjust the load of the wheel on the ground, proceed
as outlined below.
- Tighten the nut (A) to increase the load of the driving
wheel (B) on the ground.
- Unscrew the nut to reduce the load of the driving
wheel on the ground.

Adjusting the row spacing

WARNING
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
UN41 0587GN
For adjustments, proceed as outlined below.
1) Lift the work vehicle slightly off the ground.
2) Loosen the nuts (A).
3) Slide the planting unit along the frame (B) until the
required plating spacing is obtained.
English language
ADJUSTMENT INFORMATION
Repeat the same procedure to replace the ploughshares
of the other transplanting units.
A
UN41 0586GN
Adjust the gap between the planting units to obtain
the row spacing required (for distances envisaged, see
"Technical characteristics" for model concerned).
Keep the minimum distance stated on the illustration
between the seedlings and the tractor wheels.
C
4) Tighten the nuts (A).
To plant the seedlings in bare ground, adjust the plant-
ing units so that the seedlings are kept (C) cm 10 - 12
away from tractor wheel.
19
10 - 12 10 - 12 10 - 12
C C
cm cm cm
5
B
10 - 12
C
cm
Use and maintenance