Add Engine Oil - Generac 1536-1 El Manual Del Propietario

• Place the handle onto the handle supports already
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the holes from the
outside of the unit and attach a plastic knob from the
inside of the unit. Tighten by hand (Figure 3).
Figure 3 — Secure Handle
• Insert the "J" hook into the second from the left slot in
the accessory tray (Figure 4).
Figure 4 — Place "J" Hook on Accessory Tray
• Pinch the chemical hose that comes out of a hole in the
unit's base and slide it into the metal clip, as shown in
Figure 5.
Generac Portable Products 2,100 PSI High Pressure Washer
Handle
Handle
Supports
Figure 5 — Slide Chemical Hose into Metal Clip
• Tilt the unit up by the handle and attach the metal clip to
the rib on the left underside of the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Figure 6 — Slide Metal Clip onto Accessory Tray

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Add Gasoline
WARNING!
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING!
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
6
Never fill fuel tank indoors. Never
Never fill fuel tank completely full.