Using The Timers; Using Daily Timer And Recording Timer - JVC UX-P30 Manual De Instrucciones

Using the Timers

There are three timers available—Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit (see page 9). When you press TIMER on the unit for
more than 3 seconds, the display alternates between
"ADJUST" and "CLOCK" for about 5 seconds.

Using Daily Timer and Recording Timer

You can set the timer whether the unit is on or off.
When the on-time comes, the unit automatically turns on (the
indicator flashes just before the on-time, and continues
flashing while the timer is operating). Then, when the off-
time comes, the unit automatically turns off (on standby).
The timer setting remains in memory until you change it.
• When the DAILY indicator is lit on the display, the timer
acts as the Daily Timer. Once the Daily Timer has been set,
it will be activated at the same time everyday until the timer
is turned off.
• When the REC indicator is lit on the display, the timer acts
as the Recording Timer. After the Recording Timer has
been performed, the details of the setting remain stored but
the timer is turned off.
Before you start...
When using " TUNER" as the source to play, make sure to
select the desired station before turning off the power.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Press and hold TIMER for more
than 3 seconds.
The timer ( ) indicator lights up, and the
timer mode indicator (DAILY or REC) and
the current on-time flash on the display.
The unit enters on-time setting mode.
[ DAILY ]
2
Set the on-time you want
the unit to turn on at.
1) Press ¢ or 4 to set the
hour, then press TIMER.
2) Press ¢ or 4 to set the
minute, then press TIMER.
The unit enters off-time setting mode.
[ DAILY ]
19
3
Set the off-time you want
the unit to turn off (on
standby) at.
1) Press ¢ or 4 to set the
2) Press ¢ or 4 to set the
The unit enters source selecting mode.
4
Press ¢ or 4 to select
the timer mode (Daily
Timer or Recording Timer)
and the source to play, then
press TIMER.
• Each time you press ¢ or 4,
5
Press ¢ or 4 to set the
volume level.
• You can select the volume level
TIMER
7
4 ¢
TIMER
hour, then press TIMER.
minute, then press TIMER.
the timer mode and the source
change as follows:
DAILY TUNER REC
DAILY
TAPE
DAILY
TUNER: tunes into the last station you were
listening to. (Daily Timer)
REC TUNER: records the last station you were
listening to. (Recording Timer)
• Put a recordable cassette into the deck.
DAILY
CD: plays a CD. (Daily Timer)
DAILY
TAPE: plays a tape. (Daily Timer)
• Make sure that the tape direction is
correct.
("VOLUME 0" to "VOLUME 40"
and "VOLUME –"). If you select " VOLUME –," the
volume is set to the last level when the unit has been
turned off.
To turn off the volume while the Recording Timer
TUNER) is working, set the volume level
( REC
"VOLUME 0."
7
4 ¢
TIMER
7
4 ¢
TIMER
TUNER
DAILY CD
7
4 ¢