Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Selecting the Sources and Starting Play
To play back CDs, press CD 3/8. (See pages 13 – 15.)
To play back tapes, press TAPE 2 3. (See page 16.)
To listen to the FM/AM broadcasts, press FM/AM. (See
pages 11 – 12.)
To select the external equipment as the source, press AUX.
TAPE
CD
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between "VOLUME 0"
and "VOLUME 40."
When using the remote control, press
VOLUME + to increase the volume or
press VOLUME – to decrease it.
When using the unit, turn VOLUME + / –
clockwise (+) to increase the volume
or counterclockwise (–) to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
FM/AM
AUX
–
+
VOLUME
–
+
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich ("AHB 1"
and "AHB 2"), full bass at low volume. This function only
affects the playback sound, but does not affect your
recording.
To get the effect, press AHB (Active Hyper
Bass) PRO until "AHB 1" or "AHB 2" appears
on the display. The BASS indicator also lights
up on the display.
• Each time you press the button, the bass sound change as
follows:
AHB 1
AHB OFF
(Canceled)
"AHB 2" has much more bass reinforcement effect than
"AHB 1."
To cancel the effect, press AHB PRO until "AHB OFF"
appears on the display. The BASS indicator goes off.
Selecting the Sound Modes
You can select one of the 4 preset sound modes. This function
only affects the playback sound, but does not affect your
recording.
To select the sound modes, press
SOUND MODE (or SOUND on the unit)
until the sound mode you want appears on the
display. The SOUND indicator also lights up
on the display.
• Each time you press the button, the sound modes change as
follows:
ROCK
FLAT
JAZZ
(Canceled)
ROCK:
Gives a heavy sound. Boosts low and high
frequency.
POP:
Good for vocal music.
CLASSIC: Good for classical music.
JAZZ:
Gives a feeling of live atmosphere. Good for
acoustic music.
FLAT:
The sound mode is canceled. The SOUND
indicator goes off.
AHB
PRO
AHB PRO
BASS
AHB 2
SOUND
MODE
SOUND
SOUND
POP
CLASSIC
10
Publicidad
Capítulos
Tabla de contenido
