Basic Disc Operations; Programming The Playing Order Of The Tracks -Program Play - JVC UX-P30 Manual De Instrucciones

Basic Disc Operations

While playing a disc, you can do the following operations.
To stop play for a moment
Press CD 3/8.
While pausing, the elapsed playing time
flashes on the display.
To resume playing, press CD 3/8 again.
To go to another track
Press MULTI KEY > / MULTI KEY < or
¢ / 4 repeatedly before or during
playback.
• MULTI KEY > or ¢ :
Skips to the beginning of the next or
succeeding tracks.
• MULTI KEY < or 4 :
Goes back to the beginning of the
current or previous tracks.
To locate a particular point in a track
During play, press and hold ¢ or 4.
• ¢ : Fast-forwards the tracks.
• 4 : Fast-reverses the tracks.
Programming the Playing Order of the Tracks
—Program Play
You can arrange the order in which tracks play before you
start playing. You can program up to 20 tracks.
On the remote control ONLY:
1
Load a disc.
• If the current playing source is not the CD player,
press CD 3/8, then 7 before going to the next step.
2
Press PROG (program).
The PRGM (program) indicator lights up
on the display.
PRGM
• If a program has been stored in memory, the program
is called up.
3
Press MULTI KEY > or MULTI KEY < to
select the track number, then press SET.
CD
PRGM
Track number
MULTI KEY
4
Repeat step 3 to program other tracks you
want.
5
Press CD 3/8.
The tracks are played in the order
you have programed.
To stop playing, press 7.
To exit from Program play mode, press 7 before or after
playing. The PRGM (program) indicator goes off. All the
programed tracks will be cleared.
• Disc ejection also erases the program.
To check the program contents
You can check the program contents by pressing
PROG (program) on the remote control.
The programed tracks are shown in the
programed order.
To modify the program
Before or after playing, you can erase the last
programed track by pressing CANCEL on the
remote control.
• Each time you press the button, the last
programed track is erased from the program.
PROG
To add tracks in the program before playing, simply select
the track numbers you want to add by following step 3 of the
programming procedure.
• If you try to program the 21st track
"FULL" will appear on the display.
• If the total playing time is 100 minutes or more
The total playing time will not be shown. "– –:– –" will appear on
the display.
Continued
MULTI KEY
SET
Program step number
CD
PROG
CANCEL
14