Introduction; Using An Hvlp Spray Gun; Preparing To Spray; Selecting A Spray Pattern - WAGNER HVLP Manual Del Usuario

Introduction

This spray gun is designed for use as a High Volume/Low Pressure
(HVLP) painting system.
With an HVLP system, the highest quality professional finish can be
achieved with little preparation or setup time. HVLP systems are
not intended to replace airless systems. Instead, they are meant to
compliment airless by improving the final finish on the substrate,
minimizing waste, and reducing labor time.
This HVLP spray gun with regulator is designed to be used with an
air compressor. Please review all the information contained in this
manual before operating your HVLP spray gun.
Material Flow
Adj. Knob
Packing Nut
Trigger
Check Valve
Pressure
Gauge
Regulator
NOTE: The cup locking lever secures the cup to the spray
gun.
© Wagner Spray Tech. All rights reserved.

using an hvLP Spray Gun

Preparing to Spray

1. Release the cup locking lever and remove the cup.
2. Make sure that the cup and the cup gasket is clean and in
position. Fill the cup with the desired painting material.
3. Place the cup on the spray gun and tighten the cup locking
lever.
4. Attach the air supply hose to the air inlet fitting at the bottom
of the gun handle.
5. Turn on the air supply.
Air Cap Ring

Selecting a Spray Pattern

The spray pattern is adjusted by turning the air cap into either a
Air Cap
vertical, horizontal, or diagonal position. To turn the air cap, grasp
the two front tabs and twist. Never trigger the gun while adjusting
the spray pattern.
Fluid Inlet
Cup Locking
Lever
1-Quart Cup
Assembly
3
Air Cap Tabs
Vertical Horizontal
Tip Position Pattern
Diagonal
Tip Position
Horizontal
Tip Position
English
Round
Pattern
Vertical
Pattern