Festo CP FB5-E Breve Descripción página 16

CP FB5-E
Circuit example of operating voltage connection
AC
DC
24 V
10 %
±
!
Operating voltage can be switched off separately
! External fuses
" PE
# Potential equalization
Earth cable connection pin 4 designed for 12 A
Terminating resistor on the last fieldbus slave
If the CP system is at the end of the fieldbus system, a cable
termination is required.
Recommendation: Use the Sub-D plug from Festo (part no.
18529) for this purpose. A suitable RC network has already
been fitted into the housing of the Festo Sub-D plug. The cable
termination must be switched manually (refer to manual "CP
fieldbus node 5").
16
10 A
24 V 3,15 A
0 V
#
"
9903a