Transport, Storage And Disposal - Madas RG/2MT Serie Manual De Instrucciones

5.0 - MAINTENANCE
• Before carrying out any dismantling operation on the device, make sure that there is no pressurised gas inside.
To check the status of the filter element (7) (the following operations can only be carried out for versions with
in-line fittings)
• Loosen the fastening screws (8) and very carefully remove the bottom cover (10) from the body (5);
• Extract the filter element (7) and check its condition. Blow it and clean it and, if necessary, replace it (see figure on the
next page for the positioning);
• Check the conditions of the sealing O-Ring (11) of the bottom cover (10), and replace it if necessary;
• Make sure the sealing O-Ring (11) of the bottom cover (10) is inside the relevant groove before putting it back on;
• Reassemble the bottom cover (10) and secure it in its original position, being very careful not to "pinch" or damage the
O-ring during tightening.
IMPORTANT: make sure that the centre pin (4) is centred in the guide of the bottom cover (10);
• Tighten the screws gradually, following a "cross" pattern, until the torque (tolerance -15%) indicated in table 1 on page 27
is reached. Use a calibrated torque wrench to do this.
• Check the body/cover tightness;
NOTE: for internal inspections, it is recommended to:
• Also check the obturator's integrity and, if necessary, replace the rubber seal (9);
• Replace the seals before reassembling.
fig a: Cover without bottom cover
Guides for
filter element

6.0 - TRANSPORT, STORAGE AND DISPOSAL

• During transport the material needs to be handled with care,
avoiding any impact or vibrations to the device;
• If the product has any surface treatments (e.g. painting,
cataphoresis, etc) it must not be damaged during transport;
• The transport and storage temperatures must observe the
values provided on the rating plate;
• If the device is not installed immediately after delivery
it must be correctly placed in storage in a dry and clean
place;
• In humid facilities, it is necessary to use driers or heating
to avoid condensation.
• At the end of its service life, the product is to be disposed of
in compliance with legislation in force in the country where
this operation is performed.
Madas Technical Manual - REV. 0 of 10 May 2018
th
7.0 - WARRANTY
The warranty conditions agreed with the manufacturer at the
time of the supply apply.
For damage caused by:
• Improper use of the device;
• Failure to observe the requirements described in this
document;
• Failure to observe the regulations pertaining to installation;
• tampering, modification and use of non-original spare parts;
are not covered by the rights of the warranty or compensation for
damage.
The warranty also excludes maintenance work, the assembly
of parts of other manufacturers, making changes to the
device and natural wear.
13
The filter element must
be placed inside these
guides
RG/2MT... - FRG/2MT...