Transport And Storage; Transport And Storage Of Cordless Tools; The Rotary Hammer Is Not In Working Order; The Rotary Hammer Is In Working Order - Hilti TE 4-A22 Manual Del Usuario

7 Transport and storage

7.1 Transport and storage of cordless tools

Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.

8.2 The rotary hammer is not in working order

Malfunction
The LEDs indicate nothing.
1 LED blinks.
4 LEDs blink.

8.3 The rotary hammer is in working order

Trouble or fault
No hammering action.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293208 / 000 / 00
Possible cause
The battery is not fully inserted.
The battery is discharged.
The battery is discharged.
The battery is too hot or too cold.
The rotary hammer has been over-
loaded briefly.
Possible cause
The rotary hammer is too cold.
The function selector switch is set
to "Drilling without hammering"
Action to be taken
▶ Push the battery in until it
engages with a double click.
▶ Change the battery and charge
the empty battery.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
Action to be taken
▶ Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Set the function selector switch
. to "Hammer drilling" .
7