Intended Use; Lithium­ion Battery Status Display; Items Supplied; Rotary Hammer - Hilti TE 4-A22 Manual Del Usuario

▶ Do not take apart, squash or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place the power tool in a non-flammable
location, well away from flammable materials, where it can be kept under observation and left to cool
down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Parts, operating controls and indicators
Dust shield
@
Chuck
;
Accessory tool release
=
Function selector switch
%
Depth gauge
&
Forward / reverse selector switch with
(
safety lock
Control switch
)

3.2 Intended use

The product described is a battery-powered rotary hammer. It is designed for hammer drilling in concrete
and masonry, for drilling in steel, wood and masonry and for driving and removing screws.
▶ Use only Hilti lithium­ion batteries of the B 18 / B 22 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Lithium­ion battery status display
When the lithium-ion battery is used the charge status can be displayed by tapping one of the battery release
buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Indication of the charge status is not possible while the power tool is in operation or immediately after
operation. If the battery charge status LEDs flash, please refer to the information given in the Troubleshooting
section.

3.4 Items supplied

Rotary hammer, side handle, depth gauge, operating instructions.
The TE DRS-4-A (01) dust removal module is available as an accessory that greatly reduces dust emissions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data

4.1 Rotary hammer

Weight
Single impact energy
Drilling diameter range in concrete/masonry (hammer drilling)
Drilling diameter range in concrete/masonry (hammer drilling)
Drilling diameter range in wood (solid)
4
Printed: 27.07.2016 | Doc-Nr: PUB / 5293208 / 000 / 00
1
Grip
+
Battery
§
Charge state and fault display (Li-ion
/
battery)
Battery release buttons
:
Connection for the TE DRS-4-A(01) dust
∙
removal module
Side handle
$
Meaning
• Charge status: 75 % to 100 %
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %
TE 4­A22
7.3 lb
(3.3 kg)
2 J
13/64 in ... 5/8 in
5 mm ... 16 mm
1/8 in ... 25/32 in