Hanging The Fan - Progress Lighting Airpro P2553 Manual De Instalación

Hanging the Fan

REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE: This fan is recommended for
standard ceiling mount using the downrod
provided with this fan. When using standard
ceiling installation with the 4.5 inch downrod
provided, the distance from the ceiling
to the bottom of the fan blades will be
approximately 12.1 inches.
Standard Ceiling Mounting
1. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove
the mounting plate. (Figure 5)
2. Remove the hanger pin and locking pin
from downrod assembly.
3. Route the wires exiting the top of the fan
motor . Make sure the slot openings are
on top. Route the wires through the canopy
and then through the
ball/downrod
assembly. (Figure 6)
Loosen, but do not remove, the set screws
4.
on the collar on the top of the motor
housing.
5. Align the holes at the bottom of the
downrod with the holes in the collar on top
of the motor housing. (Figure 6)
6.
Carefully insert the hanger pin through the
holes in the collar and downrod. Be careful
not to jam the hanger pin against the wiring
inside the downrod. Insert the locking pin
through the hole near the end of the hanger
pin until it snaps into its locked position, as
noted in the circle inset of Figure 6.
7.
Re-tighten the set screws on the motor collar
on top of the motor housing.
8.
Proceed to "Installing the Fan" section.
Loosen but Do Not Remove
FAILURE TO PROPERLY INSTALL SET SCREWS
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Motor wires
Ball/Downrod
assembly
Canopy
Hanger
pin
Motor
collar
Remove
Figure 5
Pin in
locked
position
Locking
pin
Tighten screws
Reverse
switch
Figure 6
4.