DOOR REVERSAL
INSTRUCTIONS
1. Lay the unit on it's back.
2. Remove the kickplate by removing the three
retaining screws. (locations shown in Fig E1)
3. Remove the four screws located on the lower
door hinge. (Fig E2)
4. Pull the door downward until it releases from the
upper hinge pin.
5. Remove the plastic screw cap from the top left
hand (Fig E3) side and install it on the top right
hand side of the door frame.
6. Unscrew the upper door hinge (Fig E4) pin from
the right side of the worktop and install it on the left
side of the worktop.
INSTALLATION INSTRUCTIONS
7. Position the main door back on the cabinet and
push up until the top hinge pin is inserted into the
top of the door.
8. Remove the lower support pin from the door and
reposition it on the lower hinge as shown in
Fig E5.
9. Re-install the lower support pin on the right side
of the door.
10. Make sure to align the door and cabinet before
fastening the lower hinge screws to the cabinet.
11.
Re-install the kickplate.
3