Assembly Instructions - Danby Diplomat DAR163BLDP Manual De Instructions Pare El Uso Y Cuidado De Su Unidad

ASSEMBLY INSTRUCTIONS

1. Installation of top rail (as shown in Fig.1.)
2. Installation of CO2 Cylinder Support: Install the
cylinder support onto the four studs located on the
exterior back wall of the cabinet. (no tools required)
Align the holes in the cylinder support with the studs
and push down firmly. See Fig. 2
WARNING
ALWAYS EXERCISE EXTREME CAUTION WHEN
HANDLING PRESSURIZED C02 CYLINDERS.
1. Protective Plate (Pre-installed): To prevent
unnecessary damage (marring) to the floor of
the refrigerator cabinet, the protective plate
should always be installed when the keg stand
is being used. The protective plate also makes
installation and removal of the keg and keg
stand easier.
2. Installation of the Beer Keg: Position the keg
stand directly in front of the open refrigerator
cabinet. Using proper lifting technique, (using
keg handles only) carefully lift the beer keg onto
the keg stand. See Fig. 3
NOTE: The keg stand is required when using 30 Liter
(1/4 barrel) "pony" style kegs only. To install the beer
keg and stand inside the refrigerator cabinet, brace your
knees behind the keg stand and grasp the keg stand
handles. Lift the front of the keg stand just enough so
that the front edge of the stand is resting on the
front edge of the refrigerator cabinet.(See Fig.4) Grasp
the keg stand (front) handles and "carefully" slide the
keg stand all the way into the refrigerator cabinet.
ASSEMBLY INSTRUCTIONS
Fig.1
Fig.2
Fig.3
Fig.4
6