Installation - Truper TAN-PI10 Manual Del Usuario

Connections
CAUTION • Pull the pressure relapse ring (A) to make
sure is safe to open the tank.
• Loosen by hand and release the four cover locks (B).
• Straighten the hoses completely.
• Connect one end of the paint hose into the product outlet (C)
and the other end to the spay gun product inlet (C
• Connect one end of the air hose into the air outlet (D) in the
tank cover and the other end into the spray gun air inlet (D
• Connect the compressor hose to the paint tank air inlet (E).
Filling the bucket
CAUTION • Do not fill up the tank without the paint
bucket (F). First, prepare the mix in the bucket and then set
up the bucket into the tank (G).
• Fill up the tank until reaching the inner bucket handles (H).
F
C
1
Closing the tank
• Be careful not to tangle the hoses. Set the cover
onto the tank aligning the cover mounts ( I ) with
the respective locks.
• Make sure the cover sits correctly on the washer.
• Set the locks onto the mounts. Do it alternatively
to make sure the cover closes perfectly. Turn by
hand to tighten each one.
CAUTION
Do not use a spanner to tighten.
• Make sure the product fill up
CAUTION
cap ( J ) is perfectly closed.
ENGLISH
8
1 ).
H
G
D
1

Installation

D
C
).
1
J
I
A
E
B