Troubleshooting; Warranty Policy - Truper TAN-PI10 Manual Del Usuario

Problem
Air is flowing out from
the regulator port.
Pressure slowly drops in
the regulator.
Liquid or air is leaking
through the cover joint.
Paint settles fast inside
the tank.
The gauge is not
registering the air
pressure.
The safety valve jumps
out.
Model Code
TAN-PI10 16908
This product, its parts and components have a one year cover against any defects in material and/or workmanship as well
as its function, without expense for the customer. This warranty excludes the following: 1) when product is used under
different from normal conditions; 2) usage in breach of the operating manual furnished or; 3) when this product has
been altered or repaired by personnel not certified by
This warranty shall be effective with the supplier selling the product, or at
Centers listed in this manual.
This warranty shall be effective when presenting the product and the valid Warranty policy duly stamped by the supplier
or the proof of purchase.
To comply with this warranty, Truper will cover transportation expenses in case consumer's address is out of range from
numbers: 01 (800) 690-6990 or 01(800) 018-7873.
In the event of any problem regarding the validity of this warranty please call toll-free numbers mentioned above.
Parts, components, consumables and accessories when applicable may be acquired at
Service Centers listed herein.
1
TEL. 01(761) 782 91 00, FAX 01(761) 782 91 70, (TIN) R.F.C.: THE-791105-HP2
10
ENGLISH
Cause
• The regulator diaphragm in the tank
is damaged or broken .
• The regulator valve is dirty or worn.
• The accessories are loose or air is
leaking.
• The cover joint is defective.
• Some locks are loose.
• There is dirt or foreign material
between the joint and the edge.
• The paint in not sufficiently mixed or
thinned.
• The air inlet regulator is OFF.
• The gauge is defective.
• The tank pressure is too high.
• The safety valve is defective.
Brand
Authorized Service Centers listed herein or at the website www.truper.com or at our toll-free
Imported by:
Parque Industrial No.1, Jilotepec, C.P. 54240, Estado de México, México
www.truper.com

Troubleshooting

Solution
• Go to a
Service Center to replace it.
• Go to a
Service Center to replace it.
• Tighten the loose accessories or remove
and set them back with new thread sealing
tape.
• Replace the cover joint.
• Tighten al the lock with the same tightness.
• Clean the edge and the joint.
• Mix or thin the paint flowing the
manufacturer instructions.
• Turn ON the air inlet regulator.
• Go to a
Service Center to replace it.
• Reduce the tank pressure from 25 PSI to
30 PSI.
• Go to a
Service Center to replace it.

Warranty Policy

.
TRUPER, S.A. de C.V.
06-2018
Autorized
Autorized
Autorized
Autorized
Authorized Service
Authorized