Safety Warnings For Using Paint Tanks - Truper TAN-PI10 Manual Del Usuario

Substances and materials
CAUTION • The equipment is designed to apply
covering materials, like paint, varnish, enamel, etc. These
materials can have a flash point not lower to 70 °F. See the
can label or container of the product.
WARNING • Do not spray substances you are not
familiar with and not knowable of their potential danger.
WARNING • Do not spray flammable substances.
• Use care with dangers originated by the sprayed
substances. Consult the text and information in cans and
container, or the manufacturer specifications.
CAUTION
• Do not use acids, caustic solutions or
halogenated hydrocarbon solvents.These substances may
attack the cap washer and the safety valve seal
compromising the tank capability to maintain pressure.
Accessories and modifications
WARNING
• Do not modify the tank design or
construction. Drilling the tank or changing its design
weakens the structure and may cause an explosion.
WARNING • Do not try to alter the safety valve
adjustment to change the factory-made configuration.
WARNING • Interchanging not recommended
accessories may weaken the tank or cause failure in the
components. Use only components included with the tank
or recommended by
WARNING • Double check the accessories
connected into the tank are designed to hold pressures
higher than the tank pressure. The accessories designed
for lower pressure could explode and cause severe
injuries.
6
ENGLISH
Safety Warnings for
Before using the paint tank
WARNING
filling up cap, first, pull the pressure release ring to assure
there is no pressure accumulated and is safe to open the
tank. Otherwise, the cap could shoot out and cause severe
injuries.
CAUTION
perfect working condition.
WARNING
using the tank. Otherwise the user is exposed to an
explosion due to high pressure.
CAUTION
are in good repair and the connections are right.
CAUTION
turning on the compressor.
WARNING
not use tools to tighten. Tightening in excess may cause
the vices weaken and suddenly get loose causing a violent
explosion.
While using the paint tank
WARNING
the filling cap while the compressor is on and the tank is
pressurized.
.
After using the paint tank
WARNING
application and before opening the tank cover, be sure to
release the accumulated pressure in the tank. Pull the
pressure release ring until the pressurized air is released
completely. Otherwise, the tank cover could shoot out
causing severe injuries.
WARNING
following the instructions in this manual. Confirm all the
ports are free of hardened paint or other materials that
could hinder free air circulation. A careless cleaning may
cause the pressure to raise to dangerous levels.
Using Paint Tanks
• Each time you open the tank or the
• Double check all the parts are in
• Replace any damaged part before
• Assure all the connections and hoses
• Double check the cap is closed before
• Tighten the cap vices by hand. Do
• Never try to open the tank cover or
• Upon finishing the product
• Clean and dry the tank and the cover