Mounting Options; Installation Procedures - American Standard Avery 1180SB3020 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MOUNTING OPTIONS

* NOTE: Chinaware dimensions can vary. Please use the actual size of the sink that you
REPLACEMENT USE
When replacing an original unit be sure to shut off water supply before removing the lavatory or disconnecting
water supply lines and drain fittings. Original supplies and shutoff valves should be replaced on installation.

INSTALLATION PROCEDURES

Typical installation includes cabinet support preparation, installation of faucet and pop-up drain, connection of flexible water
supply lines, attachment of sink to cabinet, sizing and installation of drain, supplies to house water system.
Sink Mounting Provisions
Whether the sink is used for replacement or new installation, the cabinet area beneath the sink must be reinforced to provide
sufficient support. The wood support frame for the sink must support 400 pounds (approximate weight of sink when full and a
garbage disposal installed).
CABINET SUPPORT PREPERATION
Important Note:
This installation assumes the use of a custom cabinet and countertop design. It is not designed for use with standard base
cabinets or standard countertops. Installation must be performed by a professional cabinet maker and shall be in accordance
with all local plumbing and building codes requirements.
FLUSH MOUNT or UNDER COUNTERTOP INSTALLATIONS
1
WALL PREPARATION:
Determine if the sink will be flush mounted or under countertop mounted. Next measure the actual size of the sink being
installed to determine cabinet opening dimensions and support frame location. The cabinet opening should equal the
maximum dimensions of the sink to ensure a minimum gap between the sink apron and the cabinet. Support frame location
is determined by type of sink installation being performed.
TOP SURFACE OF SINK & COUNTERTOP
ENSURE LEVEL BEFORE SECURING
H & C SUPPIES
FRAME
RUNNING FRONT
TYP. BOTH SIDES
Flush Mount
Installation *
will be installing in order to determine the cutout dimensions for your countertop.
SINK
COUNTERTOP
Under Countertop
Installation *
COUNTERTOP
FLUSH MOUNT
INSTALLATION
SHOWN
SUPPORT
NOMINAL SIZE
FRAME
RUNNING SIDE
TYP. FRONT & REAR
- 2 -
7302028-101

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Avery 1180sb3320Avery 1180sb3620Avery 1180db3620

Tabla de contenido