American Standard Avery 1180SB3020 Instrucciones De Instalación página 4

4A
FLUSH MOUNT INSTALLATION
Using carpenters square carefully measure and mark the location of the cutout opening in the countertop. Flush mount
cutout opening is determined from the actual sink size. The cutout opening should equal the maximum dimensions of the
sink to ensure a minimum gap between the sink and the countertop opening.
Note: Check dimensions on first page as a reference and measure the sink being installed.
4B
UNDER COUNTERTOP INSTALLATION
Under countertop mount cutout opening is determined by cabinet opening and should be 3/8" (9.5 mm) smaller than the
inner sides of sink and from back of sink apron. Carefully cut out the countertop opening, opening must be adequately
finished and sealed to prevent damage from water absorption.
Note: Check dimensions on first page as a reference and measure the sink being installed.
3/8"
(9.5 mm)
3/8"
(9.5 mm)
COUNTERTOP
1" (25 mm)
CUTOUT DIMENSION
CABINET OPENING DIMENSION
ACTUAL SINK
DIMENSIONS
COUNTERTOP
CUTOUT DIMENSIONS
ACTUAL SINK DIMENSIONS
COUNTERTOP CUTOUT DIMENSIONS
COUNTERTOP
DIMENSION
1" (25 mm)
• SOLID SINK WALLS
• CENTER DRAIN HOLE
- 4 -
1"
(25 mm)
CUTOUT
ACTUAL SINK
DIMENSIONS
7302028-101