Flush Mount Installation - American Standard Avery 1180SB3020 Instrucciones De Instalación

2
SUPPORT FRAME
Construct a support frame to fit inside the cabinet opening. Ensure you provide proper clearance for faucet, water supply lines,
drain assembly, garbage disposal mounting system and the structural parts of the cabinet.
Flush Mount Installation Note:
Ensure to install the support frame so that the top rim of the sink, (when placed within the frame), will be level and flush with the
top surface of the countertop, (when countertop is installed). See diagram 2A below.
Under Countertop Mount Installation Note:
Ensure to install the support frame so that the top rim of the sink (when placed within the frame) is level and flush with top
surface of the cabinet. (Top of sink rim must be flush and level with top of cabinet in order to obtain proper contact with the
underside of the countertop). See diagram 2B below.
FRAME MEMBERS
RUNNING FRONT
TYP. BOTH SIDES
UNDER COUNTERTOP
MOUNT INSTALLATION
3
SINK INSTALLATION
CAUTION: Sinks are extremely heavy. For personal safety, always use
extra personnel for installation.
STEP 1. Carefully set the sink within the support frame and position in center
of cabinet opening. If flush mounted ensure that the sink top rim
surface is level and flush with the countertop top surface, (when
countertop is installed). If under countertop mounted ensure that
the sink top rim is level and flush with cabinet top surface. Check
clearance around sink apron and ensure sink is centered within
cabinet opening. Ensure sink base is making proper contact with
support frame. Adjust or shim as needed to obtain proper sink
position and fit.
STEP 2. Carefully remove sink and place a thin layer of sealant around top
edge of support frame where the sink and frame will make contact.
Then replace sink back into position. See diagram below.
COUNTERTOP
SINK
SINK TO BE LEVEL AND FLUSH
WITH THE TOP SURFACE OF
THE COUNTERTOP
SINK SUPPORT FRAME
FRAME MEMBERS RUNNING
SIDE TO SIDE TYP. FRONT & REAR
2B
FLUSH MOUNT
INSTALLATION
SINK
PLACE A THIN LAYER OF
SEALANT AROUND TOP
EDGE OF SUPPORT FRAME
- 3 -
2A
TOP OF SINK RIM MUST
BE FLUSH AND LEVEL
WITH TOP OF CABINET
TOP OF CABINET
7302028-101