Sub-Zero ICB424G Guía De Uso Y Mantenimiento página 4

STORAGE
Storage Drawers
DRAWER DIVIDER
To remove the divider, pull it forward and release the back
edge from notches in the drawer. Lift up and out. Reverse to
reinstall. Refer to the illustration below.
Drawer divider.
DRAWER REMOVAL
To remove, pull the storage drawer forward until it stops.
Lift the front of the drawer slightly and pull straight out. To
reinstall, place drawer onto the slides, then align the holes at
the front of the drawer with the pegs on the slides. Refer to
the illustration below.
For model ICB427RG, the upper drawer has a control cable
that must be disconnected before removing the drawer.
Refer to the illustration below.
PEG
Storage drawer removal. Control cable
(model ICB427RG).
|
4 English
OPERATION
Interior Lighting
CABINET LIGHTING
Rope-style lighting is mounted to the top of the cabinet.
Refer to the illustration below. For models with a display
rack, additional lighting is mounted in the control panel
to illuminate the display rack. Cabinet lighting must be
replaced by Sub-Zero factory certified service.
STORAGE DRAWER LIGHTING
Model ICB427RG | Drawer lighting uses a 25-watt bulb.
The bulb is recessed into the top of each drawer compart-
ment. To access the bulb, pull the drawer forward until it
stops or remove the drawer. Refer to the illustration below.
WARNING
Turn power off at the control panel before replacing light
bulbs. Wear protective gloves when handling bulbs.
CABINET
LIGHTING
RECESSED BULB
Cabinet lighting. Storage drawer lighting.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.
To initiate Sabbath mode, while the unit is on, touch
the control panel. Touch and hold for 10 seconds. This
will turn the unit on and lights will be disabled. To return to
normal operating conditions, touch .
CARE RECOMMENDATIONS
Cleaning
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights, control panel
and the cherrywood facing on wine racks.
Use a standard glass cleaner to clean the UV-resistant glass
door.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.
on
CONDENSER CLEANING
CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
Models ICB424G, ICB424FSG, ICB427G and ICB427RG
The condenser is located at the bottom of the unit, behind
the kickplate. To access, remove the kickplate. Refer to the
illustration below.
Model ICBWS-30 | The condenser is located behind the
flip-up grille. To access, pull out on the bottom edge of the
grille and rotate upward. Refer to the illustration below.
Use a soft bristle brush and vacuum to remove dust and lint
from the condenser. Clean the condenser every three to six
months.
IMPORTANT NOTE: To avoid damaging the condenser,
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
CONDENSER
CONDENSER
Condenser (ICB427RG shown). Model ICBWS-30.
|