Yakima ShowBoat 66 Manual Del Usuario página 2

ATTENTION! FOR CANOE LOADING GO TO PAGE 12.
PREPARE REAR PASSENGER
SIDE CLAMP
Some thicker factory bars may
require the use of the longer t-bolts
included with this product.
Back off adjustment knob all
the way (but do not remove it).
ADJUST BAIL POSITION
ROUND
BARS
TOP NOTCH
PLACE REAR CLAMP ON SUPPORT BAR
Open the red lever.
Instruction #1034172C-2/57
Rotate t-bolt.
SQUARE
BARS
UPPER NOTCH
Be sure to check ShowBoat carton, or Yakima.com for approved fits.
Slide clamp onto the bar.
Tip: Identify clamp
by reading Icon on
underside of clamp. Here
the rear passenger side
icon is shown.
90°
If necessary, remove bail from current notch in
clamp, and snap it into correct notch in clamp.
FACTORY
CROSSBARS
For any factory bar fit notes specific to your vehicle: See Yakima fit
list, Yakima.com, or call customer service at (888) 925-4621.
Open the clamp.
CHOOSE BEST NOTCH
FOR MOST SECURE GRIP
Close red lever.