Yakima ShowBoat 66 Manual Del Usuario página 3

CHECK TO SEE IF CLAMP IS ADJUSTED PROPERLY
The clamp should not move with red lever in closed
position, but should slide freely with red lever open.
PREPARE FRONT PASSENGER SIDE CLAMP
Some thicker factory bars may
require the use of the longer t-bolts
included with this product.
Back off adjustment knob all the
way (but do not remove it).
ADJUST BAIL POSITION
ROUND
BARS
TOP NOTCH
Instruction #1034172C-3/57
Rotate t-bolt.
SQUARE
BARS
UPPER NOTCH
fits. For any factory bar fit notes specific to your vehicle: See Yakima
To tighten clamp, open the red lever, and
rotate clockwise a full turn as shown. Then
close red lever, and check to be sure clamp
does not slide on bar. Repeat as necessary.
passenger
side icon.
(Disregard number for kayak installation.)
90°
If necessary, remove bail from current notch in
clamp, and snap it into correct notch in clamp.
FACTORY
CROSSBARS
FOR MOST SECURE GRIP
* Be sure to check ShowBoat carton, or Yakima.com for approved
fit list, Yakima.com, or call customer service at (888) 925-4621.
Front
Open the clamp.
CHOOSE BEST NOTCH