Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LOADING YOUR BOAT(S)
NOTE: Be sure to load your boat slowly the
first time to ensure that you don't damage your
hull. Re-position if necessary to avoid contact.
Open both red levers. Pull middle of
roller backward until it meets the
stop collar. Close red levers.
NOTE: If roller does not extend
easily, re-align the clamps (step 14).
Lean boat against roller so
that no contact between
boat and vehicle occurs.
NOTE: Always keep one
hand on boat while loading.
TIP: To protect your boat's finish
use your personal floatation device
(PFD) to rest your boat on.
CAUTION: Potential for
contact between hull
and ShowBoat!
For more clearance, canoe installation
is recommended, but with roller
installed in upward orientation.
Instruction #1034172C-9/57
Push boat onto vehicle
using roller while lifting
rear of boat.
Publicidad
Tabla de contenido
