Before Requesting Repairs Or Testing - Citizen CH-4532 Manual Del Usuario

BEFORE REQUESTING REPAIRS OR TESTING

Make sure to check the following before sending your blood pressure monitor away
to be tested or repaired.
Problem
Display stays blank when
you press the "START/
STOP" switch.
No measurements can
be taken.
Your blood pressure readings are abnormally high or
low compared with those taken in hospital.
Other phenomena
Checks
Check whether the
batteries are dead.
Check whether the
batteries are installed the
right way round (
oriented correctly).
Check whether the
measurement icon
displayed.
Check whether the cuff is
attached correctly.
Did you stay calm during
measurement?
Note that blood pressure measurement may not be
possible for someone with an extremely weak pulse
or cardiac arrhythmia (irregular pulse).
- Eng 23 -
Response
Replace all the batteries
with new ones.
Load the batteries in the
correct direction.
and
Attach the cuff properly.
is
Measure your blood
pressure again, making
sure to remain still.
See page 22.
Remove the batteries from
the unit and change them
with new ones.