System Installation - GE GXSV65R Manual Del Propietario E Instalación

MOUNTING SYSTEM INSTALLATION
of removing filter canisters (see Fig. 5). Allow enough space on either side of the system for the tubing
connections.
SCREW INSTALLATION
1. Remove this template from the manual for easier installation.
2. The top of the template openings should be placed a minimum of 17 inches above the bottom of the cabinet
or floor where the system is to be mounted (Fig. 4 and 5).
NOTE: Any distance lower may result in filter canisters interfering with the floor when removed.
3. Tape template to wall, then mark the wall where the screws are to be installed.
Install screws into the wall, leaving 3/16 inch clearance between the head of the screw and wall (drill pilot holes
if needed) (Fig. 6).
17 inches
Fig. 5
10
Installation Instructions
5 inches
Template for screw hole pattern on back of filtration system
Bottom of Cabinet or Floor
5 inches
Screws
17 inches
3/16 inch
Screw
Fig. 4
Wall
Fig. 6
49-50323