Installation Instructions
MOUNTING SYSTEM INSTALLATION (CONT.)
Mounting System to Screws Installed in Wall
1. Remove shrink wrap from filter system.
3. If the head of the screw will not slide into the upper slot, back out the screw by 1/4 turn and try again.
4. If the system is too loose when placed on the wall, tighten the screws by 1/4 turn and try again until a desired
fit is achieved. Alternately, it is possible to remove the top of the manifold during installation and tighten the
5 inches
Min.
17 inches
Fig. 7
11
49-50323