Suspension Mounting - ETI Solid State Lighting VT-4-70-840-MV-D Guía De Uso Y Cuidado

suspension Mounting

noTe: Separate mounting hardware (not included) not shown to actual size.
1
Preparing to mount the fixture
□ Drill two 1/16 in. diameter holes 33 1/2 inches apart in
the ceiling to accommodate hook screws (not included).
□ Install the hook screws into the mounting surface,
making sure to fasten the combo wood-machine end into
the metal hook.
□ Tighten the hook screws (not included) into the studs.
noTe: Eye hooks (not included) or toggle bolts (not
included) can be used as alternate methods of attaching
the fixture to the ceiling.
3
Hanging the fixture
□ Hook the V clip (DD) on each end of the fixture to the metal hooks installed in the ceiling.
noTe: Product should be suspended using metal chain or hooks with weight bearing capacity exceeding 11 lbs (5 KG).
B
A
2
Installing the bracket and clip for
hanging
□ Snap the U bracket (CC) onto the back of the fixture
body (B) near one end.
□ Insert the ends of the V clip (DD) into the openings in the
U bracket (CC).
□ Repeat the installation process for the U bracket (CC) and
V clip (DD) on the other end of the fixture body (B).
A
DD
CC
7
Please contact 1-855-384-7754 for further assistance.
DD
CC
B
www.ETiSSL.com