Completing The Installation; Linking Fixtures - ETI Solid State Lighting VT-4-70-840-MV-D Guía De Uso Y Cuidado

surface Mounting (continued)
2

Completing the installation

□ Snap the fixture body (B) into the U brackets (CC) installed on the mounting surface.
□ Restore the power supply to turn on the light.

Linking Fixtures

WarninG: RISK OF ELECTRIC SHOCK. Disconnect power to the vapor tight light before linking additional fixtures.
WarninG: Provide power to the fixtures only after all linking connections have been made.
□ Multiple vapor tight lights can be connected, up to a maximum of 7 fixtures. Only the first light fixture needs to be direct wired to an
electrical box.
□ Use a flathead screwdriver to remove a knock out hole on the end of the fixture body (B).
□ Connect additional black, white, green, purple, and gray wires to those from the power source and the electrical box on the first
fixture.
□ Feed the wires into a connector plug or through the knock out hole on the end of the fixture body (B), depending on the wiring
method preferred by the installer.
If feeding the wires through the knock out hole, an additional cord grip (not included) will be required.
noTe:
CC
B
A
Knock out holes
Cord grips
9
Please contact 1-855-384-7754 for further assistance.
B
A
CC B
www.ETiSSL.com