Yakima Q Stretch Kit Manual Del Usuario página 3

Remove the rear rack.
• Remove base pads.
• Set on a sturdy flat work surface.
Determine which
Q-Clips are required.
It may be necessary to change your rear Q-Clips. To determine if you must change
your Q-Clip see the Yakima FitList, your original Clip Sheet, or visit Yakima.com/
measurements. If it is necessary to change your Q-Clip follow these steps:
1033431D-3/30
old clip
NOTE: The Q-Tower Stretch Kit can only be used on approved vehicles.
Verify that your vehicle is eligible to use a Q-Tower Stretch Kit.
new clip