Yakima Q Stretch Kit Manual Del Usuario página 4

Find the measurement for your car with a Q-Stretch Kit.
• Find your car's M3 in the clip sheet, or at Yakima.com/measurements.
• Position towers at the new M3 distance, measuring from inboard tower edges.
TIP: To center crossbar between towers after setting your measurement use this
technique. While pushing downward and rotating the crossbar, adjust the crossbar as
needed to the left or right. Double check your M3 measurement and adjust if necessary.
Tighten tower/bar assembly.
Be sure to not
move the towers.
Install end caps and correct pads.
Keep the pads clean and free of
debris. Clean pads as necessary,
and keep them clean by not
setting them on a dirty surface.
1033431D-4/30
Pull the measuring tape tight to ensure accurate measurements.
Measurements must be accurate to within 1/8" (3.2 mm).
Note: Set measurements on a flat surface away from vehicle.
3
M
2X
Snap the
covers shut.
2X