Yakima Q Stretch Kit Manual Del Usuario página 9

CHECK EACH CLIP! (Perform safety checks with doors open)
Pull each clip away from car. PULL
HaRD! REPEaT TWICE. Clip should
not move on second pull.
CHECK REAR TOWERS!
Grip the bar outboard to towers;
push up using only arm strength.
Once installed, easy on easy off without tools.
REMOVING THE RACKS
1033431D-9/30
If any of the clips or towers move, check the gold slider positions,
tightening adjustment posts gradually. (If there is still movement
after fine tuning, verify the M1 and M3 measurements.)
• Unlock towers and
open cam covers.
• Unhook and remove
Stretch Kit bars.
• Remove rear
crossbar and towers.
• Remove front
crossbar and towers.
CHECK FRONT TOWERS!
Grip the bar inboard to
towers; push and pull
using only arm strength.
INSTALLING RACKS AGAIN
• Open cam covers.
• Clean roof and place towers at
M2 and M4 positions; measure
carefully.
• attach Stretch Kit Bars.
• Make sure clips are seated
properly, then close cam covers
with firm resistance.
Perform safety checks on all towers
and clips after every installation!