Getting Started - Hama Cube Instrucciones De Uso

Warning – Batteries
• Only use batteries (or rechargeable batteries) that match the speci ed type.
• Do not mix old and new batteries or batteries of a different type or make.
• When inserting batteries, note the correct polarity (+ and - markings) and insert the
batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the speci ed type.
• Do not overcharge batteries.
• Do not short circuit the batteries/rechargeable batteries and keep them away from
uncoated metal objects.

4. Getting started

4.1 Inserting the batteries
Open the battery compartment (13), remove the contact breaker and then close the
battery compartment (13).
4.2. Replacing the batteries
• Open the battery compartment (13), remove and properly dispose of the dead
batteries and insert two new AAA batteries with the correct polarity. Replace the
battery compartment (13) cover.
5. Operation
5.1 Automatic date/time setting using the DCF signal
• Once you have inserted the battery, the display is switched on, an acoustic signal
sounds and the alarm clock automatically starts searching for a DCF signal. During
the search, the radio symbol
• Once radio signal receiving is successful, the display shows the symbol "radio tower"
continuously.no ashing. This process can take 7 to 5 minutes.
• When the wireless signal is received, the date and time are automatically set.
ashes.
3