Stopping The Engine; Using The Self-Propel Drive; Recycling The Clippings; Bagging The Clippings - Toro Recycler 20332C Manual Del Operador

Note: If the mower does not start after several
attempts, contact an Authorized Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 13).
Note: If the mower does not freely roll backward
after self-propelling, stop walking, hold your hands in
place, and allow the mower to roll a couple of inches
(centimeters) forward to disengage the wheel drive. You
can also try reaching just under the personal pace handle
to the metal handle and push the mower forward a
couple of inches (centimeters). If the mower still does
not roll backward easily, contact an Authorized Service
Dealer.
Figure 12
Figure 13

Stopping the Engine

To stop the engine, release the blade control bar.
Note: Remove the ignition key when you leave the
mower (electric-start models only).
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower and the bag-on-demand
lever is in the bagging position, move the lever
to the recycling position (refer to Operating the
Bag-on-Demand Lever) before recycling the clippings.
If the side-discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
recycling the clippings.

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
bagging the clippings. If the bag-on-demand lever is in
the recycling position, move it to the bagging position
(refer to Operating the Bag-on-Demand Lever).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.

Installing the Grass Bag

1. Raise and hold up the rear deflector (Figure 14).
9