Installing The Grass Bag; Stopping The Engine; Recycling The Clippings; Bagging The Clippings - Toro Recycler 20330 Manual Del Operador

Note: The maximum self-propel ground speed is fixed.
To reduce the ground speed, increase the space between
the self-propel drive bar and the handle.

Stopping the Engine

To stop the engine, release the blade control bar.
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before recycling the clippings.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
recycling the clippings.

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
A worn grass bag could allow small stones
and other similar debris to be thrown in the
operator's or bystander's direction and result in
serious personal injury or death to the operator
or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
bagging the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.

Installing the Grass Bag

1. Raise and hold up the rear deflector (Figure 12).
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the
bag rest in the notches on the handle (Figure 12).
3. Lower the rear deflector.

Removing the Grass Bag

To remove the bag, reverse the steps above.
8
Figure 12
3. Grass bag pin (2)