PRESIDENT AA50075 Manual Del Operador página 30

G G
B B
card).
The relay will be activated at each opening or closing.
T
RAFFIC SIGNAL MANAGEMENT
When the gate is close the traffic signal is OFF.
When it opens, the red light switches on (3-4).
When the gate is open the green light switches on (5-6) and the red
light switches off.
The green light stays on until the starting of the automatic closing.
When the gate closes the green light switches off and the red light
switches on.
When the closing is completed the traffic signal is OFF.
B
ATTERY CHARGE CARD
The time for the complete recharge of 12Vdc 1,2Ah batteries (n° 2
pieces connected in series, optional cod. ACG9511), at the first
installation is of 24 hours, with a charge current of 0,03A.
BATTERY STATE SIGNALLING PILOT LIGHT FEEDIN (TERMINALS
3-11)
In case the network tension lacks and the emergency battery is
operated, this pilot light switches on thus signalling the network lack,
and it starts lightening only when the battery is discharged. When the
pilot light lightens, the gearcase is no longer operative.
Only when the network tension is back, the pilot light switches off and
all controls are restored. (obviously the battery will only recharge in the
presence of the network tension).
N.B.: IN CASE WE EXCEED WITH THE PILOT LIGHTS, THE LOGIC
OF THE GEARCASE WILL RESULT DAMAGED WITH A
POSSIBLE BLOCK OF THE OPERATIONS.
FUNCTIONING WITH BLACK OUT
If a battery is connected to the gearcase, with lack of network tension
the battery state pilot light switches on thus signalling the functioning
with battery. The functioning of the barrier is ensured until a charge
level of about 20V, after which there will be a signal given by the
recharge card to the microprocessor which blocks the barrier and
makes the battery state pilot light lighten. When the network tension is
back, the recharge card will start recharging the battery.
You just need pressing the remote control (or the opening button or the
step by step button) to open the barrier. Once the barrier will be open,
give a closing command or wait the pause time before the automatic
closing. The barrier starts closing. When it is closed, the normal
functions will be restored.
If no battery is connected to the gearcase, there is no particular
procedure to follow. When the network tension is back, it is sufficient to
press the remote control, the opening button or the step by step button
to open the barrier. When the barrier is open, give a closing command
or wait the pause time before the automatic closing. The barrier starts
closing.
When it is closed, the normal functions will be restored.
During the realignment the securities are active.
code ACG4661 for PRESIDENT 24V
M
OON REMOTE CONTROL
ACG6082 - MOON 433
ACG7026 - MOON 91
C
ODE LEARNING SYSTEM RADIORECEIVERS
RX91/A quarzata and coupling
RX433/A super eterodyne and coupling
RX433/A 2CH super eterodyne, 2 channel and coupling
S
PARK
To obtain the best performances of the above mentioned devices, you
have to install an aerial tuned on the installed radio receiver frequency.
N.B. Keep much attention that the central wire of the cable does
not enter in touch with the external copper braiding, which
would nullify the functioning of the aerial.
The aerial must be installed perpendicularly and must be in the sight of
the remote control.
ANTENNA SPARK 91
ANTENNA SPARK 433
SPARK FLASHLIGHT 24V 20W with incorporated intermittent card
ACG6081 - MOON 433
ACG7025 - MOON 91
code ACG5005
code ACG5055
code ACG5051
code ACG5454
code ACG5252
code ACG7061