Sterling 6500 Serie Manual Del Usuario página 4

Measure
here.
Measure distance
"D" above curves in
the corners.
Angled
Base
Warning:
are curved or angled, measure above the curve or
angle. Failure to do so can result in an improperly cut
bottom track and can void the warranty.
1. Measure and Cut the Bottom Track
IMPORTANT! Risk of product damage. If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure above the curve or
angle could result in the bottom track being cut too short.
Carefully measure the width (distance D) of the finished opening.
Consult the chart below to determine whether or not your installation will need a filler jamb.
Model # Dimension D
65**-30
65**-30
65**-33
65**-33
65**-36
65**-36
65**-39
65**-39
NOTE: If dimension "D" is falls in a range that can be either with or without the filler jamb, use the filler
jamb in your installation.
If your installation does not require a filler jamb, subtract 2-3/4" (7 cm) from dimension "D" and cut
the bottom track to this dimension. For best results, use a 32-teeth hacksaw blade and a miter box.
If your installation does require a filler jamb, subtract 3-3/4" (9.5 cm) from "D" and cut the bottom
track to this dimension. For best results, use a 32-teeth hacksaw blade and a miter box.
1034028-2-E
Measure
here.
Curved
Base
D
Measure carefully. If your walls
27-1/2" (69.9 cm) - 29-1/2" (74.9 cm)
29-1/2" (74.9 cm) - 30-1/2" (76.2 cm)
30-1/2" (76.2 cm) - 32-1/2" (82.6 cm)
32-1/2" (82.6 cm) - 33-1/2" (85.1 cm)
33" (83.8 cm) - 35" (88.9 cm)
35" (88.9 cm) - 36" (91.4 cm)
36-1/2" (92.7 cm) - 38-1/2" (97.8 cm)
38-1/2" (97.8 cm) - 39-1/2" (100.3 cm) Needed
Bottom Track
Front Edge
Filler Jamb Required?
Not needed
Needed
Not needed
Needed
Not needed
Needed
Not needed
4
Shower Ledge
Inside of
Shower
Sterling