Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install the Adjustment Clamps
Insert four adjustment clamps into each wall jamb as shown (eight total).
Partially thread the provided panhead screws through the pre-drilled holes in the wall jambs and
into each adjustment clamp using a Phillips screwdriver. Do not tighten the screws at this time.
1034028-2-E
Adjustment Clamp
Top View
Wall Jamb
Wall Jamb
Note:
Do not fully
tighten screw.
#8-18 x 1/2" Screw
Wall Jamb
6
Sterling
Publicidad
Tabla de contenido
