Sterling 6500 Serie Manual Del Usuario página 8

Wall
Jamb
Bottom Track
4. Caulk and Install Bottom Track
Insert the bottom track and check for proper fit. The lip of the bottom track should face toward the
outside of the shower. The ends of the bottom track should fit snugly against the front protrusions
in the wall jambs.
Remove the bottom track and apply silicone sealant in the groove at the bottom front edge of the
bottom track.
Install the bottom track.
5. Assemble the Hinge Jamb
Lay the hinge jamb on the floor or on a workbench. Use a drop cloth to protect the product finish.
Insert the front side of the hinge into the slot on the hinge jamb.
Secure the hinge to the hinge jamb using four provided flathead screws. Make sure the top edge of
the hinge is flush with the top edge of the hinge jamb before tightening the screws.
Align the slotted holes on the hinge with the channel in the door panel. Make sure the top edge of
the hinge assembly is flush with the top of the channel.
1034028-2-E
Apply
sealant.
Note:
Use silicone
tub & tile type
caulk.
Bottom Track
Flathead Screw
#8-18 x 1/2"
Hinge
Hinge
Jamb
Insert the hinge
into the slot
making sure the
top edges are
flush.
8
Hinge
Hinge
Jamb
Hinge Jamb
Sterling