Operating Instructions - Drinkwell FCB-AU-17 Manual De Funcionamiento

Operating Instructions

.
Important: DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
Note: Rinse all fountain parts with warm water before operating
the pet fountain. This will remove any dust or residue that remain in
the system from the manufacturing process.
1. Carefully remove all the Pet Fountain components from the
packaging and set aside prior to assembly.
2. As with any electrical device, check the electrical Power Cord
for any tears or damage before use.
3. Make sure the In-Line Plug is connected. When connected properly the silver tip is
not showing.
4. Remove the Housing by pressing the side tabs and lifting up. Inspect the inside of the Pet
Fountain to ensure Pump is securely attached (Fig. 1). Snap Housing back into place.
5. Remove the Housing Lid and set aside.
6. Insert the Charcoal Filter. The Charcoal Filter fits diagonally into the two triangular slots
located inside the Housing. The Charcoal Filter fits narrow side down, with the black
side facing the front of the Pet Fountain towards the spout. The Charcoal Filter will slide
easily into place, but make sure it is pushed all the way down (Fig. 2 & 3).
Important: Rinse the Charcoal Filter thoroughly under cool water before placing in the
Pet Fountain. This will remove any loose charcoal dust, which is harmless. A small amount
of charcoal dust may be released for the life of the Charcoal Filter. This is normal and is
not harmful to your pet.
7. Fill the Bowl with water. Replace the Housing Lid.
8. Place the Pet Fountain in desired location. Do not pick up a full Pet Fountain by the
Housing. Only pick up the Pet Fountain by placing both hands underneath the base of
the Pet Fountain and grip the sidewalls for a sturdy hold. Important: To protect your
floor always use a protective mat such as a towel or water-resistant placement. This will
help protect your floor from any splashing or spills caused by your pet.
9. Before you plug in the Pet Fountain, make sure the electrical Power Cord, the plug,
and your hands are dry. Plug the Pet Fountain into a standard electrical wall outlet.
10. Set your desired flow rate with the Flow Control Knob, which is located to the right of
the receiving ramp inside the Bowl. When the Flow Control Knob is in the 10 o'clock
position, flow is at its lowest. When the Flow Control Knob is in the 2 o'clock position,
flow is at its highest.
Fig. 2
Charcoal
Filter
www.petsafe.net
Fig. 1
Pump
Fig. 3
7